Exterior Painting Preparation

[crismacana]

There is nothing better than stepping back and seeing the progress you have made over the last few minutes, how fresh the new paint looks, how the new color livens and beautifies the way it looks from the curb. Whether you are using a roller, a brush, or a spray rig, putting new paint on your house is a very satisfying feeling, and while it is work, it goes pretty quickly once you get going.

But before you can get going you have to prep.

In one sense, paint prep is about making the job of painting go as smoothly and efficiently as possible. Also to minimize the chances of the painter making a mess of things that do not need paint on them. On a deeper level, the prep process is to ensure that the paint coating will work to preserve the structure of your home.

Begin your paint preparation with a long, slow look at the exterior of your home, identifying potential painting problems. Are there any bushes or plants that are (or could be) touching the house that will be in the way of painting and preparation? If so make plans to trim them or tie them back.

Are there any areas where the old paint is bubbling or cracking? These conditions will have to be corrected before painting, usually with scrapping or sanding. But try to determine why the paint failed in these areas. If it is simply a matter of the last painter doing a bad job then you
can do a better job this time. Is it an area that gets excessive moisture because of improperly installed flashing or gutters? If so you may as well fix things before painting.

Scraping and sanding can be the most labor intensive part of the job, but it is necessary. If the house gets painted every 4-6 years, you can imagine how much paint has built up on an older home. The new paint may adhere very nicely to the old paint, but that is little consolation if the old paint comes off! If bare wood is exposed during scraping and sanding, or if there is new wood from repairs, be sure to prime it before painting.

Finally, the surface that is going to be painted has to be clean. Some will tell you that washing the house is the first step in paint prep, others point out that you just have to wash again after scraping and sanding. The bottom line is there should be no dirt or moisture between your
ready-to-paint surface and your paint.

Pressure washers are seen as a time and labor saving tool for paint prep, but be careful using them. A pressure washer can remove a good deal of the old paint, taking some of the pain out of the scraping job, but many of these machines are powerful enough to do serious damage to your siding.

Finally, arrange drop clothes were they will be needed, remove or mask lighting fixtures, and use masking tape around the windows. It is nice to be able to open your first paint can early in the day while it is still cool. There is something to be said for working so that you will be on the
shady side of the house as the day gets warmer. When you're finished, treat yourself to a few minutes standing on the curb, enjoying how great your house looks. Just be sure to remove the masking tape after the paint has begun to set but before the sun sets the adhesive so well it has
to be scraped off!

[samanthasmithin]

The exterior painting guide is a good read and we can learn a lot about exterior painting from it.

Exterior wall painting is a systematic and a bit time consuming task, but the efforts put in are worth the results in the long run.

[EthanJoshua]

Painting the exterior of a house can be a demanding job. But you can save yourself a lot of work by preparing properly for the project.